MARTINDALE MM84 Guia do Utilizador descarregar pdf (Página 62)

Test Lamps

Drummond

Test Lamp - MTL7 MTL7

IMPORTANT: Voltage indicators

should always be tested with a

proving unit or known live source

before and after use - see PD690

shown opposite.

Complies with GS38 and G9/6

Double insulated oil resistant and

flame retardant cable with black

outer and white inner for easy

detection of cuts and abrasions.

HRC fuse

The Drummond range of test lamps all offer exceptional build quality and

performance. The main body and probe incorporate large finger guards for user

safety. Housed in a tough moulded body is a 240V 15W special rough service filament

lamp which is shielded by a translucent cover. An HRC fuse is incorporated within the

body for electrical protection.

A 1.3m long double insulated EPR/CSP cable connects the main body to the probe.

This is oil resistant and flame retardant and is also double insulated with a black outer

and white inner to give visual warning of cuts and abrasions. The conductor is very

flexible multi-stranded tinned copper with a cross sectional area of 2.5mm.

The high insulation moulded probe handle houses a current limiting resistor and a

second HRC fuse (fast acting HRC 500ma 600V) which is accessible via the

removable finger guard.

The screw-in probes have insulation to within less than 4mm of the tip. The

Drummond range fully complies with GS38.

Drummond lamps are widely specified by electrical utilities and other large, safety

conscious organisations.

DRUMTL7 test lamp £29.00

DRUMTL1000 replacement bulb £3.05

The classic John Drummond test lamp is fuse

protected and complies with GS38. This makes it ideal

for low cost voltage testing.

The lamp gives clear positive indication of the

presence of voltage and is not sensitive to the

presence of phantom voltages.

Also consider the VII3700G on page 41 and the

non-contact TEK200 on page 42.

Test lamps should always be proved safe, both before

and after use. This can be done by testing on a known

live circuit, using the continuity tester, or through the

recommended proving unit (PD690).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Comentários a estes Manuais

Sem comentários

MARTINDALE MM84 Guia do Utilizador Página 62

Comentários a estes Manuais

Manuais e produtos relacionados com Multímetros MARTINDALE MM84